I need help with my screen being blank. On my Ender 3 Pro | 3DMeltdown 3D Printing | Page 1

solar summit Mar 28, 2023, 12:31 AM

#

Ah, that sounds like something's gone wrong with flashing that firmware... You can try doing the same steps again (sometimes it just fails, so putting it on the microSD card and plugging that in, then starting up the printer again might help), or if that doesn't work after like 3 tries tops, something is most likely incorrectly set up in the firmware you're trying to flash

stone mural Mar 28, 2023, 12:32 AM

#

I need help with my screen being blank. On my Ender 3 Pro

#

Ok do you know how to correctly flash a firmware?

#

@solar summit

solar summit Mar 28, 2023, 12:34 AM

#

Correctly flashing is just plugging in the SD card and then turning on the printer, which I assume you've done. It just has a chance to fail, on most printers' control boards

stone mural Mar 28, 2023, 12:35 AM

#

I tried doing that like 5 times and wait at least 5 minutes per time I did it.

#

And still was showing the blue screen.

solar summit Mar 28, 2023, 12:35 AM

#

Setting up firmware is a whole different animal, that depends a ton on your printer and specific hardware, as well as a bunch of preferences... Given that it's 2:30AM here, and I have a deadline to make tomorrow, I'm afraid I can not assist you with doing that

#I need help with my screen being blank. On my Ender 3 Pro