Using a Creality Ender 3 V2
#New to 3D printing not sure how to fix
silk turret
silk turret
Well I just mainly care about the line going through the whole thing the other side of that case is perfect however this side is far from
The nozzle while it’s printing pauses went the whole thing moves up but still dispenses filament at the same time it pauses causing a blob and it does it every layer
cosmic birch
Have you tuned it or is this kind of new to you still? I'm just trying to get a baseline understanding. Because there are a few things that need to be changed that lead to that. IE slicer settings, printer settings, filament temps, types.
silk turret
I’ve got the printer itself pretty tuned in everything moves nicely I’ve got the bed as level as I can so I’ve had no problems there its the settings that I don’t think are tuned in because I use cura but I printed that with the preset settings it gave me
The main problem is that line of blobs every print I’ve done has that line of blob in one particular spot and the rest of the print usually goes ok
cosmic birch
These are typically called zits and you have a nice line of them. I'd look at if you have combing options or z hop options set. Then you will need to look at the retraction settings. There are options to set on layer change retractions you can look at, but like I said this can be alot of things all happening at once. Check your z seam alignment and look at your temps going too hot can make the filament ooze out. Take a look at this link.
https://www.simplify3d.com/support/print-quality-troubleshooting/#blobs-and-zits