For the majority of the month I have had minimal issues with printing. I had some print failures, but those were due to bad supports/support setting. Flash forward to this past week. I can't get ANYTHING to print on it. It keeps sticking to the FEP; part is on the plate, but only a thin layer, the rest sticks to the FEP. My settings are the same, the bed level is the same, the resin is the same, and I'm even using models supported by people like 3D Printing Pro, or by people on patreon. I've tried everything I can think of. I replaced the FEP, increased exposure for burn-in layers, releveled it, sanded my flexplate (a recommendation I saw by someone on youtube)I've been troubleshooting for DAYS and I honestly don't know what else there is to try.
#I'm at my wits end with my elegoo mars 2 pro
languid flame
cinder copper
what are your lift speeds? temp also could be a factor
mystic acorn
yup, lower your lift speeds
also pre-supported models are not a sure fire thing, even if its from someone you perceive to by "good". model support and orientation is a complex topic and is heavily effected by your lift speeds, resin viscosity and temp. My general advice is for people to take the hard roan and start learning how to support your own models, dont leave it in the hands of someone else, they arent going to pay you back for lost time and resin.
languid flame
Yeah, I think it was my lift speeds. I had them set right before. I guess I must've clicked the wrong button when lychee asked me if I wanted to swap to a new profile the other day.