Soo my circuit connected to my uv lamp works, sometimes. | 3DMeltdown 3D Printing | Page 1

sullen plover Dec 29, 2022, 9:31 PM

#

[Anycubic Photon s]A while back i had big leak of resin, it destroyed my lcd and lamp. Later I found out that after cleaning uv lamp's circuit it works, so i went to replace lcd. After replacing lcd everything worked fine expect for the fact that lamp sometimes simply turn off. If i clean it once again it works. I wanted to do calibration print but lamp turned off after like 3 layers. Soo any tips how to fix it permanently?

elfin mauve Dec 31, 2022, 2:51 PM

#

its possible that something got damaged and now it overheats so it turns of for a while .... id say your printer is dead

sullen plover Jan 1, 2023, 6:00 PM

#

so
maybe i should try slap another radiator onto it?

sullen plover Jan 3, 2023, 10:25 PM

#

Okey part that i am tinkering with never had any cooling system.
Right now i kind off inspected it a little bit more and found out one pin on microprocesor is acting out

#

I cleaned him and slaped insulation tape on it, for now seems to work

sullen plover Jan 3, 2023, 11:14 PM

#

nah still something is not working

#

i managed to get 40mins of print out of it and then it turned off

#

after that i poked it with small stick and it worked again, i am flabergasted

#Soo my circuit connected to my uv lamp works, sometimes.