celest sigil
I still try to figure out the best setup for my Ender and I ran into some issues,
I used the Cura Heattower, which comes with the plugin....I followed the instructions to setup the script to lower the temperature. So this was the outcome.
I use the standard profile by Cura 5.1.0, any suggestions? It starts to get worst on the higher levels...
Second try black filament
stiff bison
Is your cooling fan turning on? Mine did the same thing with fan off but with it on it was almost perfect.
celest sigil
Yes its working. Maybe its a good hint. I will keep an eye on it
spiral dragon
Check for under extrusion the bridges will do that if there’s not enough material
scarlet sundial
The fan you want is the layer fan, not the hotend fan.
celest sigil
yes the the little on on e the right side
I runa a silent one maybe thats the problem, not enough airflow?
celest sigil
Just another test it’s definitely a problem wirh overhangs this one was printed a 200 C
scarlet sundial
Is it pla?
Try to slow down layer time and see if it works bettet
Also check the side cooling fan
Maybe is not giving enough airflow for aome reason
celest sigil
Thats the problem I guess. So I will check out the fan first