fdm-support
lifting mid print
Why am I getting these wavy lines? Happened after I messed with Y belt tension
Raised edges and material missing... no idea why
should I get a new printer?
Guys Hi!im currently building an 3d printer but have so little knowledge about firmwaresim trying
Issue with Probe Offset?
First Layer
What's going on with the corners?
Klipper
Need some help slicing a model and adding supports!
Strange problem after hotend swap
Filament wont stick to bed (even after several times leveling the bed)
mega x sound
does anyone know how to help stringing?
Creality sonic pad help
ender 3 v2 neo glass bed help
Print always has holes?
Retractions
Filament issue?
bed temp jumping around quickly
I need help with petg
Feedrate
leveling bed
what would you guys say is the cause of this?
Best bed cover material for [mainly] printing PETG?
Firmware updated bricked my printer
low spot
can’t get a successful print no matter what I do
I can't get the bed level!!!
what the hell is happening (solved)
sd card wont read after upgrading to touch screen help?>
tops not printing right
Archs not looking to good
octoprint won't start all of a sudden
Print starts of perfect but then nozzle starts to scrape the print and ruin it anyone know?
good xyz cube ?
how do you guys think I should get this small piece of filament out of my feeder
Bad first layer
Need to find a power cable for GT2560 board
is this a bed adhesion problem?
Z axis motor/leadscrew issues.
Consistent Z wobble/noise every ~65mm
ender 3 wobble
Longer LK5 pro leaving zits and a z Axis seam
Ruaway Temp - Ender 3 v2
I cant get rid of strining
Bryce - underextrusion
Sudden Z Offset?
is my nozzle still too high?
weird bubbles in prints