rugged salmon
Hi fellow simmers,
I'm new and this is my first post. I'm using MobiFlight for a while now but now I have some troubles with my configs.
I'm building an A320 Pedestal and I have an Arduino on a self designed PCB.
Unfortunately for the MODE selector on the Radar Panel I only planned 3 inputs on the PCB (so one less than needed) because I did the same earlier with the ENG MODE Selector.
With only one missing input out of three it always worked with "On release" of CRANK or IGN, switch back to NORMAL.
But with one missing out of four it doesn't work. I thought, if I would say "On release of WX+T+HZD", it would go to "MAP" only if I don't select another pin-driven option.
But when I switch from WX+T+HZD to WX+T sometimes it goes this or that way.
Is there any possibility to say "if no pin is pressed use MAP, else use the pin input?
I tried on my own and later with Gemini but after some minutes, Gemini was even more confused than me.
Thank you a lot.
- Jo
MSFS 24
MobiFlight 11
FENIX A320
Arduino
cold dew
MobiFlight!