Potentiometer Issues on MSFS 2024

[plush pewter]

So, I just "finished" my cadet yoke (the buttons are still no wired to the arduino Mega). But testing the yoke I found some issues with Aileron and Elevator pots. At first i tougth that was a filtering issue, so I added a simple RC filter using a 10uF electrolityc capacitor between gnd and signal pin, and a 220 ohm resistor in series with the signal pin on my 5K linear pors. And indeed it worked filtering all the noise, on the cuadrant it worked perfectly, but on the yoke I have those extrange movements. I read that the mega had 16 analog inputs but in practice they are just 1 ADC input multiplexed along 16 pins. But i couldn't find any info about that.

Any sugestion?

Pd. I'm not a native english speaker, but in order to improve my skils I'm not using any kind of translator. So, sorry for any grammatical error.

[finite yoke]

Hello, your english is fine, and understandable!

I am suspecting wiring might be a problem, are you using dupint cables?

[tropic flint]

Unfortunately I've seen lots of problems with axis inputs using MSFS2024, others have as well. If you have more than one axis input and there's any jitter at all the others do not behave well. It appears to be an MSFS2024 issue.

an easy way to find out is to run MSFS2020 instead and see if you have the same problem.

[finite yoke]

or pass the pots via vjoy to the sim