Tried a search first regarding this but did not see one. So for some reason Mobiflight is not seeing any of my Modules. I tried using a different port and another board but I just get no connected Modules found. I gried a system Re-boot just in case and still nothing. I have never had the issue before so I am not sure how tp proceed.
Has anyone else had this today?
#Arduino board won't connect or be recognized
vagrant mirage
tranquil stream
Did you power cycle the boards? Sometimes the Arduinos might get stuck in a bad state.
vagrant mirage
If you mean disconnecting and repowering off my Hub,then yes.
Really wierd. Never had this before today.
I tried 4 boards just to see and nothing.
Sec let me try going direct to the port on the computer with another cable.
Well crap. It seems to be an ssue with the Hub. Dang spent 50 bucks on it too to get a good one.
Ok now the Hub is working again. Sorry to have bugged you guys. I better figure something else out rather than a Hub for these boards if i can or somethiing more reliable. Who knows what happened Could have been an issue witht the port on the computer. If I find the exact cause I will post it incase someone else runs into this.
tranquil stream
Which hub is this?
vagrant mirage
sec
I might actually go for another bub with ports on the side rather than on top to better route the wires. Space is rather limited .
Perhaps like you said the Board was in some wierd state and just needed a kick in the pants from the Computer.
tranquil stream
Power cycling my boards I have had to do when even restarting Mobiflight doesn't seem to get a connection.
vagrant mirage
Wierd isn't it. Oh well all good for now. Thank you for your time.