#Input/ouput Alt Select AP - C172

1 messages · Page 1 of 1 (latest)

simple dust
#

Good afternoon , I can't get this input and output to work. The c172 ap has a double encoder for 100ft & 1000ft, but in mobiflight it only shows C_172_AP_ALT_DEC & INC . I can't find the correct output for this command. Any help? The input and output of the V / S works perfect. Thx!

glacial marsh
#

Hi Pablo.....If you are wanting to configure the dual encoder for Altitude on the Garmin g1000 nxi for c172, try the following. In the Input tab for the encoder, for "Choose Imput" select your Module and your Device. For "Imput Settings" select "Action Type": Microsoft Flight Simulator 2020. Then from the "Filter Preset List" select Microsoft / Generic / Avionics; that is from the left column drop down menu select "Microsoft", the middle column drop down menu select "Generic" and the right column select "Avionics". Then from the Select Preset you will have 303 matches, open up that drop down menu and you will see near the top the commands for AS1000_AP_ALT_DEC_100 and for 1000 Dec and for 100 and 1000 Increase for your respective "on Left" and "on Right" command tabs. I am not aware of a fast Inc and Dec option at this stage. This has worked for me so far....hope this helps😀

simple dust
#

Hi FlighKitty, it's not really the autopilot of the C172 analog or the 52 JPlogistic which is the same. Will it work the same???

glacial marsh
#

I only did this for my c172 Garmin g1000 nxi

simple dust
#

OK, I'm going to try, maybe I'm lucky! xd

glacial marsh
#

I dont know about any other planes however the commands are Generic so maybe apply to all...see how you go...

#

I'm not sure what aircraft you are trying to do this for....the commands you were originally finding are listed under the Cessna 172 / Autopilot forFilter Preset. I don't know if they work, but they only give the Increase and Decrease options.

turbid ridge
#

Which C172 are you talking of? The analog ones?
In this case you have to use the KAP140 events from HubHop. There you'll find KAP140_Knob_Outer_INC and so on (Outer/Inner and INC/DEC). The KAP140 is controlled using H-Vars.
If you want to display the selected altitude you have to use the output KAP140_ALT_ALERTER

simple dust
#

Thank you very much Ape42 I'm already trying that!