I don't know if this is the correct place to ask this question but I have a problem with the push/push knob function on the Fenix A320 FCU. I have a registered version of FSUIPC and all the Fenix presets work fine except the push/pull knob function for speed, heading and altitude to switch from OP mode to Managed Mode. Any advice would be appreciated. Renzo.
#Fenix A320 FSUIPC 7
spiral jetty
final pumice
Is this via Mobiflight? If yes what presets are you using for Push/Pull speed, heading and altitude?
spiral jetty
In FSUIPC 7, in MFS 2020, when configuring the knobs on my Virpil Control Panel, there is a preset drop down menu which contains presets for, amongst other things, PMDG 737 and Fenix A320. On the FSUIPC forum, i was told the presets were provided by Mobiflight. I am able to assign speed, heading and altitude incr and decr function to my hardware. There are also presets for push and pull FCU knobs because this is also required on the Fenix A320. Literally all the Fenix presets in FSUIPC 7 work perfectly but the pull/push function has no effect when assigned to my hardware. Sorry to explain everything longhand, but I am not that experienced with this sort of thing. Thanks.
final pumice
This is where you find all the presets for several aircrafts including the Fenix
among those presets you will find the push/pull heading, speed and altitude presets. I use them and they work fine
Now I am not sure how FSUIPC refers to those presets (this is may be where you have the problem). However, if I were you I would use Mobiflight to configure the Virpil panel (this is possible if this panel shows as HID in Windows). It would be easier and more flexible, I think
spiral jetty
Thanks. I guess I'll have to learn how to use Mobiflight. Regards.