#HDZero AIO5 ELRS Link Loss

6 messages · Page 1 of 1 (latest)

trim stirrup
#

I recently got the Happymodel Mobula6 Race HD BNF and have been to three races with it. At the first race it worked great. At the 2nd I started having receiver loss issues. At the 3rd it was losing the link consistently. LQ switches back and forth between 0 and 100 about every two seconds. If I try to arm during 0, it says bad rx. If I arm during 100, I can fly just fine without any issue until I power cycle. Here is some info about what I am using:

TX16S V1 (Preoredered)
Radiomaster Ranger 2.4GHz ELRS Module, ELRS Version 3.5.1
HDZero AIO5 (Happymodel Mobula6 Race HD BNF)
I tested 100 mW and 250 mW and many different packet rates.

Here is a video showing the issue. You can see LQ in the bottom right:
https://youtu.be/odfH9SNGRnc

Is this a known issue or does anybody have any idea what is going on?

Thanks for any help!

YouTube
Ian "1T" Beaty
ELRS Receiver Signal Loss

TX16S V1 (Preoredered)
Radiomaster Ranger 2.4GHz ELRS Module, ELRS Version 3.5.1
HDZero AIO5 (Happymodel Mobula6 Race HD BNF)

Tested 100 mW and 250 mW and many different packet rates

▶ Play video
dense sinew
trim stirrup
#

Thank you! I will look into that tonight.

#

Ok, I looked through this link and am not sure what to do. I am not a programmer and I do not see any instructions specific to what I would do on my end. Do I just wait for the next version of ELRS to come out?

#

Would the problem stop if I stop using ELRS to control the VTX?

muted hull
#

You can just disable VTXAdmin in the Lua script or flash the PR to your TX module from the configurator.