daring geyser
RX: Radiomaster RP1,
TX: Radiomaster Boxer(Elrs internal),
FC:MicoAir405v2.
It was working yesterday. But the connection was failed today. The LED of RP1 was always on.
The LED of RP1 was slow blinking when I remove RX and TX wires from RP1. The connection was failed when I moved another UART.
Thank you for your help.
daring geyser
no VTX. The drone is building. Not flight yet.
worthy dock
no VTX. The drone is building. Not flight yet.
if you removed rx and tx wires of the receiver from the FC and it's working properly
and resoldering it to any other uart ends up in the same behavior, then the issue is with the FC
you've tried every single uart on the FC?
daring geyser
Thank your suggestion. I have connect several UART and get nothing. Tomorrow I will remove RX & TX wires from RP1 and rebind them.
daring geyser
The result was the same even I removed RX & TX wires from RP1. However, I found something interested: the more I power on RP1, the more connection lost occured. I thought the RP1 was unstable?
worthy dock
The result was the same even I removed RX & TX wires from RP1. However, I found...
so you mean you're able to connect with the RP1 again?
are you getting "Telemety Lost/Recovered" Call outs?
what do you mean by "the more connection lost occured"?