tulip lily
Hey im trying to bind my FPV drone to my Jumper T20 and cant get it to work i think my controller and receiver are on different versions but not sure how to update this
Receiver says
Default Firmware: SpeedyBee Nano 2.4GHz RX 3.3.1
But on my remote it says 2.5.1
brittle carbon
Hey im trying to bind my FPV drone to my Jumper T20 and cant get it to work i th...
you will need to update the transmitter, follow the official guide https://www.expresslrs.org/quick-start/transmitters/jumper-t20-internal/
tulip lily
Perfect thank you!
tulip lily
@brittle carbon im pretty sure its connected but inputs are not showing up in beta flight however the gyro model of the drone is not moving either have i connected the drone to my Mac wrong?
brittle carbon
<@367656454087245825> im pretty sure its connected but inputs are not showing u...
get a screenshot of the Configuration tab
brittle carbon
You don't have the accelerometer enabled
That's what tells the flight controller the angle
So that's why you can't see it react
tulip lily
yeah i figured that out but the controller movments are still not working
brittle carbon
The power went out at our house, I can take a proper look when it's back up again
tulip lily
i was just using ChatGPT to try figure it out and it said this
Ensure the TX and RX wires from the SpeedyBee ELRS receiver are correctly soldered to the appropriate TX and RX pins on your flight controller.
i did TX to TX, RX to RX
tulip lily
so i need to swap it?
rugged pivot
yes
tulip lily
yay its working but now its not doing the arm switch like i put it to auto flip the switch and nothing happens
tulip lily
it needs to be tx to rx and rx to tx
Throttle is working none of the buttons/switches are
