#why wont my axisflying Thor rx bind (axisflying manta 3.6")

24 messages · Page 1 of 1 (latest)

plucky nimbus
#

So after me having a rather hard landing my drone went into boot mode. I have discovered how it went into boot mode, button was constantly being pressed as a result of said landing, yet I haven't had any luck at binding it again. I had tried to manualy bind it with no avail and am stuck trying to flash my rx to try and see if that fixes the issue yet elrs keeps on coming up with an error that I cannot seem to fix. I have tried looking it up and seeing if I can fix it but havent found an answer can I have help please.

image.png
wooden fable
plucky nimbus
plucky nimbus
wooden fable
#

could you please post the full !log file here?

glacial laurelBOT
#

See the following image to save a log file from the configurator

plucky nimbus
plucky nimbus
# wooden fable is the receiver LED still solid?

======== PASSTHROUGH INIT ========
Trying to initialize COM8 @ 420000

No CLI available. Already in passthrough mode?, If this fails reboot FC and try again!

======== RESET TO BOOTLOADER ========

  • Using full duplex (CRSF)

Cannot detect RX target, blindly flashing!

esptool.py v4.2.1
Serial port COM8
WARNING: Pre-connection option "no_reset" was selected. Connection may fail if the chip is not in bootloader or flasher stub mode.
Connecting...
.
.
.
.

this is the most recent log

wooden fable
#

If this fails reboot FC and try again!

#

are you unplugging-replugging the usb and rebooting the flight controller?

plucky nimbus
wooden fable
#

reboot the computer and FOLLOW the procedure

plucky nimbus
wooden fable
#

no.. not really, but that's just what's on the procedure

plucky nimbus
wooden fable
#

get a uart adapter and reflash through that.. or just let it go and get a new receiver, or both.

plucky nimbus
wooden fable
plucky nimbus
#

otherwise powering it up normally makes rx bling very briefly then not blink for about 2 secs