Disable receiver telemetry problem | ExpressLRS Community | Page 1

grand cargo Aug 16, 2024, 5:20 AM

#

I have connected 2 rx to my t20 tx with passphrase at the same time. I have disabled telemetry of one receiver (ep2) by using the web interface. This works fine.
After some power cycles, I get telemetry problems, because the telemetry of the ep2 was reenabled.
This ep2 is used in an antenna tracker next to the transmitter.
What can I do to permanently disable the telemetry in this receiver?

spice lark Aug 16, 2024, 7:17 PM

#

firmware version?

#

3.4.2 fixed a problem with 8285 based receivers loosing config data

grand cargo Aug 19, 2024, 10:25 AM

#

Firmware version is 3.4.0.
I will update an check again.

grand cargo Aug 21, 2024, 10:12 AM

#

Is it possible to disable telemetry by a csrf command?

#Disable receiver telemetry problem