Model Match (Half connection)

[rare skiff]

Hi all
I recently posted about not being able to flash my receiver, long behold I was trying to do so with an extracted firmware file and not using the .gz file was the mistake.
However I have now run into what I believe is a model match error (it is not stating model mismatch in the lua) I have my receiver bound (solid light) and showing a C in the lua along with the radio signal symbol on my taranis. When connected to betaflight I get no input from the sticks or aux. My Elrs firmwares are both matching Elrs 3.3.2 rx and tx
Rx geprc nano
Tx es24tx pro
Betaflight 4.4.3
Uart serial rx 3
Also this is a bnf that I have flown about 20 or so packs on and was working great until I uploaded the geprc cli dump.
I believe I was reading somewhere if you sent the model number to 255 this is essentially a null value and then undercuts the mismatch? Correct me if I’m wrong would this be my issue.

[dire notch]

Turn model match on briefly then off again

Are you sure your receiver is configured properly in Betaflight?

[rare skiff]

No luck with the toggling of model match , and I’m 95% sure it is correct
Ports serial rx 3
Reciever Mode- serial uart
Serial reciever provider - CRSF
Telemetry - on
Halfduplex - off

[dire notch]

Show a Betaflight CLI dump

How many wires go to the O3? 4 or 6?

[rare skiff]

I’m assuming 6 I will let you know when I’m home in 5hrs along with the cli dump

[dire notch]

Should be 4. !depin the yellow SBUS wire if it's connected

[bold path]

https://www.youtube.com/watch?v=fh9gvhobVro