Hi Guys, my RP1 is blinking green and wont go into Wifi Mode. Its just one Blink like a Heartbeat. I cant figure this out. Can anyone help? Thanks a lot!
#Receiver wont go into Wifi Mode
safe stag
vast minnow
Hi Guys, my RP1 is blinking green and wont go into Wifi Mode. Its just one Blink...
do the unbricking procedure (basically reflashing via passthrough with receiver in boot mode)
or reflash the receiver via uart adapter, with erase before flash option enabled
safe stag
😭 such a pain without a bootbutton. Thought there is an easy way...
vast minnow
There's a boot pad.. connect it to ground with a wire for a cleaner job..
safe stag
yeah i know thabks. Hate to do this...
proper stratus
Hello folks
My problem is more complicated, same receiver RadioMaster RP1 2.4.
- wifi - OK
- binding - OK
but the sticks and toggle switches don't work.
Cheching into betaflight Tab "Receiver"
and with https://hardwaretester.com/gamepad
Any idea how to make it work?
vast minnow
Hello folks
My problem is more complicated, same receiver RadioMaster RP1 2.4.
...
post a screenshot of the ports tab and receiver tab
post a photo of the actual receiver wiring to FC
post a screenshot of the receiver webui options and model tab
post a screenshot of the ExpressLRS Lua Script with TX and RX bound/connected
then finally, if you are on dji vtx, make sure the sbus wire is disconnected
proper stratus
ports tab:
Receiver tab:
last item: post a screenshot of the ExpressLRS Lua Script with TX and RX bound/connected
I can send that in about five hours when I'm near the RC (RadioMasterTx12).
vast minnow
also post a screenshot of the receiver tab with the receiver and tx module bound/connected
and the modes tab.. (while receiver and tx module were bound/connected)
