celest crag
Bought a Radiomaster Boxer
EdgeTX 2.8.1.
ELRS3.2
Drone is a GEPRC Cinebot30 BF 4.4, ELRS 3.2.
Binding does not work with bind phrase, drone cannot be forces into binding mode with attaching/detaching battery.
pressing "bind" button on Radiomaster boxer causes menu to hang until it is powered off.
any ideas where to even start looking?
I have flashed many times with and without bind phrase, but the only thing happening is wifi.
grizzled sand
Bought a Radiomaster Boxer
EdgeTX 2.8.1.
ELRS3.2
Drone is a GEPRC Cinebot30 BF ...
does the ExpressLRS Lua Script load on the tools page in the system menu?
celest crag
yes it does, and I upgrade that on FW upgrade
grizzled sand
could you put the tx module/radio and receiver into wifi mode and post a screenshot of the WebUI Options Tab please.. like so:
!webui
storm pewterBOT
Connect to your transmitter's or receiver's WiFi network to access the web UI:
celest crag
yes, that works for both TX and Rx
grizzled sand
yes, that works for both TX and Rx
I mean, put both tx and rx into wifi mode and post screenshots of the WebUI options tab here
celest crag
well TX wifi no longer works it seems, it pops up on wifi, but immediately dissapears, also if I exit and try to go back module gets stuck on loading screen
grizzled sand
well TX wifi no longer works it seems, it pops up on wifi, but immediately dissa...
reflashed the module yet?
via ETX passthrough?
celest crag
yes, a few times
grizzled sand
yes, a few times
did you set it up with your local wifi credentials?
celest crag
no, using AP mode
grizzled sand
no, using AP mode
have you tried using a different device to connect to the wifi access point?
like your smartphone?
celest crag
yes, it pops up on wifi, then dissapears after 5s, the TX wifi worked 30 minutes ago, reflashing with elrs configurator now
successful reflahs
but now wifi does not show at all
also, if I change any setting, like packet rate, the change does not save, if I exit the module and go back, it gets stuck on "loading" screen until poweroff
grizzled sand
also, if I change any setting, like packet rate, the change does not save, if I ...
do you have set the external module off?
grizzled sand
am I correct only ExpressLRS 3.2 is supported on this unit?
yes, Boxer can only use 3.2.0 as the target has just been made on this release
celest crag
well the wifi AP no longer works either, can only access it through USB
I guess it is broken. that could explain why bind phrase binding does not work, but it does not explain why the RX cannot get in to old bind mode
grizzled sand
I guess it is broken. that could explain why bind phrase binding does not work, ...
if receiver has a binding phrase, then it won't activate manual binding mode
celest crag
it doesn't even after I flashed it without phrase
but since TX only hangs when I press bind I guess it would not help
it does seem this is broken on delivery, is there anything else left to try?
grizzled sand
it does seem this is broken on delivery, is there anything else left to try?
contact Radiomaster support
celest crag
will do, thanks for the help 🙂
