Skyzone ELRS backpack not changing band and/or channel on goggles

[haughty sigil]

I have 04x goggles with stock receiver in right bay, ELRS backpack receiver in left bay, steadyview X enabled, followed skyzones instructions for flashing binding phrase. Have tried manual binding mode on the video receiver module. When module powers in the goggles it lights up green for 1 sec flashes four times, not rapidly, then goes solid. I'm not sure if it is bound because it will not change band and/or channel when commanded and will not enable VRX wifi when commanded. Any ideas? Thanks.

[dapper trellis]

what tx module do you have?
are you able to put the TX Backpack into wifi mode via the Lua Script?

[haughty sigil]

@dapper trellis the betafpv micro 500mw

[dapper trellis]

can you post a photo of the back of the module please

i.e. the dipswitches position

[haughty sigil]

@dapper trellis

[dapper trellis]

set 3,4 to On, set 1,2,5,6,7 to OFF

[haughty sigil]

@dapper trellis give her whirl

@dapper trellis goggles didn't change for me

[dapper trellis]

are you able to put the TX backpack into wifi mode via the expressLRS lua script?

[haughty sigil]

@dapper trellis actually sending the command from the VTX admin put the module into wifi mode weirdly.

[dapper trellis]

are you using the correct Lua Script for the firmware version you have on the module?

[haughty sigil]

@dapper trellis OK after it went into wifi mode I flashed it with the same firmware and settings and now it's working, you are a magical unicorn brother.