I have a problem to update frimeware on betaflight micro tx 1000mw module.

[past ocean]

I have a problem to update frimware on betaflight micro tx 1000mw module. when i'm trying to flash via usb it shows this error. when i try flash via wifi it shows the second error. The dip switches are in good position. One time I updated it via wifi from factory wersion to 2.5.2 What can i do?

[sour quiver]

via UART: Drivers and Dipswitches
via WiFi: Repartitioner needed prior to 3.2.0

[past ocean]

i have drivers and dip switches correct

[sour quiver]

could you post a photo of the Device Manager with the module plugged in to usb
and also the dipswitches position at the back of the module please

[past ocean]

np

1up 2up 3down 4 down 5up 6up 7up

[sour quiver]

https://tenor.com/view/ken-jeong-community-too-small-to-read-read-reading-gif-5494204

ONLY 1,2 should be ON, 3,4,5,6,7 should be OFF

https://user-images.githubusercontent.com/1081265/208266962-2e00a222-d44f-48b8-8ea0-e4a9a8433e64.png

The BetaFPV Micro 1W module (and the updated BetaFPV Micro 500mW) has dipswitches at the back of the module. You need to set switches 1 & 2 to ON, and the rest to OFF, for flashing via USB. For normal operation switches 3 & 4 must be ON and the rest OFF. See the below diagram:

https://www.expresslrs.org/quick-start/transmitters/betafpv2400/#flashing-via-usbuart

[past ocean]

i tried in that way

but it didn't work

[sour quiver]

try it again.. and post the full log if it failed

!log

[silent plank]

See the following image to save a log file from the configurator

https://cdn.discordapp.com/attachments/798006228450017290/1025339571979960340/LogSaveToFile.jpg

[sour quiver]

the compile didn't even happen because of a permission error..

can you reboot the computer and try that again please

[past ocean]

ok

the device says no handset

now

[sour quiver]

because it is not in a handset

[past ocean]

so..... it worked