sacred rain
Good Morning,
Very new to the FPV world. Bought a Cinebot 30 with ELRS 2.4 and Zorro ELRS. I'm having issues loading the 3.2 version for the RX though. I've updated the Zorro without any issues and that's updated to the 3.2 version already.
Please help. I've watched many youtube videos, read tons of info on the ELRS discord group and read Oscar Lians "how to set up ExpressELRS 2.4GHz" without any luck. Thank you!
timber cobalt
GepRC Receiver Flashing Guide here:
https://www.expresslrs.org/quick-start/receivers/geprc2400/
What EXACT issues were you having on the receiver?
sacred rain
Actually, now after plugging the receiver in I have the options to choose from on configurator.
I guess I'm not too sure which one to choose
first time seeing these options.
timber cobalt
Actually, now after plugging the receiver in I have the options to choose from o...
these options were always there, whether the receiver is connected or not..
since you have the GEPRC Receiver, select from the GepRC category
sacred rain
You're right. Sorry about that.
When I click to build, I get this message. I don't know what I'n doing wrong at this point.
timber cobalt
When I click to build, I get this message. I don't know what I'n doing wrong at ...
sign out/reboot the computer..
once you're logged in, relaunch the Configurator
clear the dependencies first, using the buttons shown below:
!clear
timber cobalt
then build the firmware again
sacred rain
I'll give that a go now.
I've did the steps provided. Do I need to have the RX plugged in when I build the firmware again?
timber cobalt
I've did the steps provided. Do I need to have the RX plugged in when I build th...
Follow the Flashing Guide I linked above..
This will highly depend which Flashing Method you're using.
sacred rain
I did this step and it looked like it downloaded the version I wanted but when I plug the RX into the computer, expresslrs wifi doesn't show up at all on my wifi nextworks.
It's blinking rapidly right now.
humble harbor
I'm all good now. I've updated the RX to 3.2 finally. Didn't know that if you've previously setup wifi on the RX, it wouldn't show up on the network. Had to type http://elrs_rx.local into my browser for that to come up.
gloomy moth
