Cant figure this out.
#Trying to flash HM ES24TX Pro, getting an error [please select an upload port for environment]
void cloud
void cloud
May not be able to do it via usb for some reason, seems like wifi is working.
timber jewel
were you following the flashing guides?
Port issues originates from drivers not being installed, or the dipswitches aren't in the correct positions
void cloud
followed it. I had an older version which I was able to update to 2.5 before updating to 3.0.
before updating to 3.0, I updated the with the repartitioner file
once i updated the repartitioner file, none of the lights on the TX turn on other than a solid red light on the board .
void cloud
I was only getting that message when trying to update with usb
no error updating to 2.5 via wifi
new problem, no lights on the TX
timber jewel
change position of the dipswitches inside the module, plug it into usb and post a screenshot of the Device Manager, Ports group of devices expanded.
timber jewel
Drivers aren't installed properly
void cloud
fixed.
the dirver part at least.
still a bit concerned that none of the lights are coming on.
timber jewel
still a bit concerned that none of the lights are coming on.
after flashing?
void cloud
ha, they just started flashing again.
If i flash via usb, will the file system change appropriately? I only saw the instruction to flash the repartitioner file.
timber jewel
If i flash via usb, will the file system change appropriately? I only saw the in...
the repartitioner is only needed if you'll be flashing via wifi
void cloud
Ok, thats what I thought.
The reason I didnt add the driver was because when I read the instructions, it seemed that you only needed to do that with the last TX listed. I didnt know it was a next step.
timber jewel
do you have suggestions to make it more clearer?
void cloud
Maybe a header "Update your PC Driver", this will be required when flashing via USB.