#Meteor 75 walksnail elrs wont bind to tx16s Mkii
46 messages · Page 1 of 1 (latest)
can you show the flight controller on this meteor 75 please.. just want to make sure which particular receiver it has
afaik the meteor 75 ELRS version comes with Serial, and not SPI
not to mention, using ELRS config it wrote and flashed successfully.
is this the OP's meteor 75?
they couldn't post the pic to the fourum
lost?
put both TX and Rx into wifi mode, connect and load their Web UI and post a screenshot of their Options Tab
!webui
Connect to your transmitter's or receiver's WiFi network to access the web UI:
refresh this page as the config/options has not been queried
give the device an unobstructed view to the device you're using to connect to it..
dead voice chat?
yeah, voice chat is dead.. no one's there.. 😄
(I don't do voice chat.. I've not setup for that)
...
just do text chat, deadbyte just said he doesn't do vc
I asked for the Options Tab screenshots..
huh? in BF?
these:
#1059693238518300683 message
this is the TX
waiting for the RX
those UID numbers should match
they are the translated Binding Phrase..
you can update one or both from the webUI itself. no need to reflash...
once those numbers match, there should be sync/bind
use at least 8 characters for your Binding Phrase for a much higher sync success
@young junco when i was in call with you, the connection to the rx seemed really weak. try to find the wifi antenna of the pc(normally in the back), and then bring the quad close to it when you connect to the rx
okay ill try that deadbyte