Hello, I am trying to set up my VTX in betaflight on the video transmitter tab but I get an error saying "Your VTX is not configured or not supported. So you can't modify the VTX values from here. This will only be possible if the flight controller is attached to the VTX using some protocol like tramp or SmartAudio and is correctly configured in the Ports tab if needed." So then I go to the Ports tab and try to configure the VTX to the Uart it is connected to and it says "The VTX table has not been set up correctly and without it, VTX control will not be possible. Please set up the VTX table in the Video Transmitter tab"
I have no idea what I'm doing wrong but I think it's possible that I might have wired the VTX wrong to the FC if somebody could send me a picture of how their TBS VTX is wired to their FC that might be helpful.
#TBS Unify Pro32 HV Wiring and SA issues
rapid smelt
primal isle
