no handset error on axis thor module | ExpressLRS Community | Page 1

sharp anchor Oct 23, 2022, 4:34 PM

#

I have a relatively new axis flying thor that was working fine previously..
and when I turn on my QX7 to use it the radio powers it but its clear theres no communication between the radio and module...

Ive checked continuity (at multiple points) from the chip (in the radio) to the end of the cablethat goto the module..
Ive refreshed the module..
And yes, I've tried turning it off and on again, in various ways at that..
Its never been dropped (the module.. though not even the radio since having gotten the module)..

This only came to light after I got my first ELRS RX on Friday, I havnt tried to do anything otherwise on the module in a few weeks so idk exactly when this started

delicate walrus Oct 23, 2022, 4:35 PM

#

is your QX7 properly set for ExpressLRS use?
does it have the Crossfire Mod?
what baud rate is it set to?

#

https://www.expresslrs.org/3.0/quick-start/transmitters/tx-prep/

Preparing your Radio - ExpressLRS

Get your Radio Handset prepared for ExpressLRS with this setup guide.

sharp anchor Oct 23, 2022, 4:37 PM

#

delicate walrus is your QX7 properly set for ExpressLRS use? does it have the Crossfire Mod? wha...

I think its proper, no crossfire mod, I cant remember the baud rate...
ill go over the first and last shortly as im riding in the car right now and my radio is in the back

sharp anchor Oct 23, 2022, 10:45 PM

#

My bad.. let's just leave it at i got delayed... checking now

sharp anchor Oct 24, 2022, 2:25 AM

#

I think I accidentally found the fix while checking other stuff, apparently my internal radio was also on.. but I hadnt scrolled up far enough to notice

#no handset error on axis thor module