frosty tundra
Hey guys I'm on the latest RatOS 2.1.2 available as of today and my Ratrig can only home X and not Y anymore after running the wizard again.
I already found the issue in the RatOS.cfg file:
#---------------------------------------------------- Y -----------------------------------------------------
# The left Y motor used for cartesian Y control in Hybrid CoreXY, located at the rear left of the printer
# Connected to MOTOR 1 on BIGTREETECH Octopus V1.1 F446
# Driver: BTT TMC2209 v1.3
# Motor: LDO-42STH48-2504AC
# Voltage: 24
#------------------------------------------------------------------------------------------------------------
[tmc2209 stepper_y]
stealthchop_threshold: 0
interpolate: True
uart_pin: PD11
run_current: 1.6
driver_TBL: 2
driver_TOFF: 3
driver_HEND: 0
driver_HSTRT: 6
sense_resistor: 0.11
[stepper_y]
step_pin: PG0
dir_pin: PG1
enable_pin: !PF15
microsteps: 16
full_steps_per_rotation: 200
rotation_distance: 40
homing_speed: 50
#---------------------------------------------------- Y1 ----------------------------------------------------
# The right Y motor used for cartesian Y control in Hybrid CoreXY, located at the rear right of the printer
# Connected to MOTOR 3 on BIGTREETECH Octopus V1.1 F446
# Driver: BTT TMC5160T Plus v1.0
# Motor: LDO-42STH48-2504AC
# Voltage: 24
#------------------------------------------------------------------------------------------------------------
[tmc5160 stepper_y1]
stealthchop_threshold: 0
interpolate: True
cs_pin: PC7
spi_software_mosi_pin: PA7
spi_software_miso_pin: PA6
spi_software_sclk_pin: PA5
run_current: 1.6
sense_resistor: 0.022
[stepper_y1]
step_pin: PG4
dir_pin: PC1
enable_pin: !PA0
microsteps: 16
full_steps_per_rotation: 200
rotation_distance: 40
I have the default drivers coming with the ratrig package so why is one tmc2209 and the other tmc5160 after the wizard?
shell gulch