RatRig 500 IDEX
.
I fixed the VOAC stream issue thanks to reddit, but the probe and light are not working. I'm assuming I'm missing Z_Offset_Probe in my cfg, but I can't find the G code to copy and paste anywhere. I have triple checked my wiring + hardware.
#VOAC components not working
tranquil pecan
cunning voidBOT
sonic otter
So when you click here and then click the start calibration it doesn't turn the light on?
tranquil pecan
correct
sonic otter
Does anything happen?
tranquil pecan
just the camera stream with the guide image over it
tranquil pecan
I can't even start the calibration because I get the error that Z_probe_offset doesn't exist
sonic otter
Did you follow this guide? https://wiki.ratrig.com/products/v-core-4-1/commissioning-guide/idex/03-calibration
Step 5 and onward
tranquil pecan
step 5.4 I can't get past because it keeps timing out from exceeding range
I have double checked all my connections and vibration points and I'm stuck a 2.8 score
sonic otter
Can you share a screenshot of the error and the results please
tranquil pecan
(I legally cannot screenshot in this lab)
most recent test
failure is from the beacon calibrate nozzle temp offset, and I can't run the Vaoc version, because the led light + Z offset don't exist in the g code
we bought these machines pre flashed from RatRig man
sonic otter
Were they assembled by Ratrig as well?
The poke test falls in an okay range. I would heat up the nozzle to 280 and tighten, but don't use a lot of force, just turn it as much as it will go, really important not to strong arm it
tranquil pecan
nah we're assembling them in house, (aerospace 3d print lab), I did the tighten earlier sadly
I'll take a torq wrench to it tomorrow during OT
sonic otter
Gotcha, nozzle is probably good then, did you already run beacon_initial calibrate? https://wiki.ratrig.com/products/v-core-4-1/commissioning-guide/idex/02-sanity-check step 6