dense elbow
Hello,
I just upgraded my vc4 idex to a ratos 2.1 from 2.1rc2, I recovered some settings in printer.cfg. It was printing fine on older os version. And something weird happened with a new os version. My petg prints stated having melted lines in the middle, here is an example of PA calibration cube. Any ideas what’s the issue? I tried different temps, don’t see a big difference. The cube was done at 230 and bed 80
fathom arrow
I'm not familiar with printing with PETG, but this is it possible you're outrunning your maximum flow rate for your hotend? That would be a slicer setting and not a printer.cfg thing though.