magic turret
Hi, I recently got a used V-Minion 1.0 (the only updates are an Eva3 toolhead and an oldham coupler from the 1.1 update) but I'm having troubles squaring the X axis.
I included a pic of my current mesh and the setp of the guide I'm trying to follow (I can get it up to like 0.320 after a lot of trial and error, but not much more).
At this point I'm afraid some other component like the main vertical 3060 extrusion or the rail that's driving the Z axis wasn't mounted properly: how common would this scenario be? Or what else could be going on with it?
The main issue I have is the following: as much as I try, tightening the 3 screws mentioned in the guide (especially the one on the right) leads to the 2020 extrusion lifting upwards on the farthest side from the 3060 extrusion (on the right)
