#Double tap from BL touch probe

2 messages · Page 1 of 1 (latest)

gentle dome
#

Hello,
I'm on the latest RatOS 2.1 and am getting random double deployments of my BL touch probe, usually just in the center, but on larger prints at the edges. This is triggering a probe failed to deploy message sometimes . The probe is an original and about 3 years old connected to an EBB42 1.2 TB. Its has only been happening since the last OS update.

upbeat niche
#

If it’s in regions of the bed it’s likely the harness is electrically compromised and marginal.
5 thin wires in that bl-touch cable, any one goes out you’re toast.
The harness stretches differently through travel which is possibly why you’re getting inconsistent behavior.