#split_delta_z' in section 'bed_mesh' must have minimum of 0.01

2 messages · Page 1 of 1 (latest)

white idol
#

I've been running RatOS 2.1.0 for a week or so on my V4 Hybrid. Recently installed the V4.1 upgrade kit and ran a few unsuccessful prints (Orbiter 2 smart sensor tangle detection hypersensitive again with the loss of the add-on Bowden tube stabilizer). This morning Klipper showed that the version was "dirty" regarding I believe "graph_mesh_py - I did a soft restore and commenced to get the above error. I've checked previous saved versions of the RatOS.cfg files and I can find no provisions for a "split_delta_z" variable in any [Bed_Mesh] section. I'm assuming my best bet is to start from scratch with a new RatOS load on my pi, but wanted to see if there were any suggestions for a workaround. TIA

coarse glacierBOT
#

To help others find answers, you can mark your question as solved via Right click solution message -> Apps -> ✅ Mark Solution