What do I need to do | Rat Rig Community [Unofficial] | Page 1

flint saddle Nov 17, 2025, 12:17 AM

#

Started to try to print the skew correction tool started printing out good but when it hit about layer 10, it had a layer problem and then started printing the air. I don’t know what I’m doing wrong.

fringe shadowBOT Nov 17, 2025, 12:17 AM

#

To help others find answers, you can mark your question as solved via Right click solution message -> Apps -> ✅ Mark Solution

flint saddle Nov 17, 2025, 3:39 AM

#

Never mind, I got it figured it out commendation between slicer config, which there is not a lot of information on it and that filament tube was getting bounded up. I have a picture of the final print and see what you guys think later.

#

And the filament run out sensor file that was provided his junk. I deleted it because it kept on pausing my prince. It would not allow it to keep on printing.

flint saddle Nov 17, 2025, 5:22 AM

#

Besides the skirt, did it look like it printed OK?

#What do I need to do