#"Endstop y still triggered after retract" when running "BEACON_INITIAL_CALIBRATION"

4 messages · Page 1 of 1 (latest)

solemn pumice
#

Hi,

Model: VCore4 400mm IDEX
Following through calibration, only lower belts installed at this stage as per instructions.

Just done a clean install on VCore 4 400mm as I had this issue so tried a clean run first. Everything updated.

Run through the guide, checked endstops manually for each and all works as expected. When BEACON_INITIAL_CALIBRATION runs, the extruders both move to the far edges of X, then move forward towards the front of the machine and hit the Y endstop, the extruders then move toward centre slightly then I get the error "Endstop y still triggered after retract" 5 times in the console output.

Any help would be great, thank you.

solemn pumice
#

When doing the manual moving of the axis' for Y should they stay static on X and just move back and forward or with just the lower belts are they meant to move towards/away from each other before then moving the gantry forwards/backwards?

solemn pumice
#

Ah looks like I'm meant to have hybrid belts installed as its IDEX at this point, just non IDEX to skip, will attempt that first.

gentle belfry
#

ah, yeah. Can't skip hybrid belts on an IDEX setup