Whenever I home the X axis the whole X cariage moves a little bit along the Y axis. I tried to loosen the belts because I thought they were too tight but it didn´t change anything. I don´t really have any experience with this sort of stuff and when I tried to look on Google for the answer I couldn´t find anything so this is sort of my last resort. I have a VCore 4 500 IDEX but since the manual said so I didn´t put the Hybrid belts on yet.
#X cariage moves slightly along the Y axis while homing X axis
strange lotus
grizzled schoonerBOT
deep pollen
If you're doing IDEX, you have to attach the hybrid belts.
strange lotus
I know but in the instructions it says that you should do the initial calibration first before you attach the hybrid belts. Should I just instal the hybrid belts and see if that helps?
deep pollen
From what I've read in here, those "initial calibration first" only applies to hybrid. If you're doing IDEX you have to have the additional set of belts attached otherwise the motion system isn't fully constrained. Hence the extra movement
strange lotus
alright Im going to attach the hybrid belts.