Bed mesh not compensating | Rat Rig Community [Unofficial] | Page 1

prime mothBOT Jul 14, 2024, 6:37 PM

#

To help others find answers, you can mark your question as solved via Right click solution message -> Apps -> ✅ Mark Solution

fast bronze Jul 14, 2024, 11:52 PM

#

What model and size printer and is it enclosure. Also what type of filament an what bed temp are you trying to use? Its compenstating but most likely the heightmap is changing from the time it takes it till the time it starts to print

weary mortar Jul 15, 2024, 4:56 PM

#

400mm vcore 3.1 enclosure 2.0 filament ASA

#

running euclid as probe

fast bronze Jul 15, 2024, 5:01 PM

#

Are you sure the z axis is not moving at all? Do you see the steppers moving as it will be just small movements.

#

how long are you letting the printer heat soak before starting the print? Any big printer like this is going to twist and warp a little as it warms up. I have been warming up my VC3.0 for 30-45 minutes and it works fine after that. My VC4 500 that I am just finishing up seems to be the same way. Try a long heat soak and try your print again.

#Bed mesh not compensating