weird error toolboard related | Rat Rig Community [Unofficial] | Page 1

swift berry Apr 16, 2024, 1:50 PM

#

Has anyone had a random crash then ADC out of range? then

MCU 'toolboard' shutdown: Rescheduled timer in the past
This generally occurs when the micro-controller has been
requested to step at a rate higher than it is capable of
obtaining.
Once the underlying issue is corrected, use the
"FIRMWARE_RESTART" command to reset the firmware, reload the
config, and restart the host software.
Printer is shutdown

vague gullBOT Apr 16, 2024, 1:50 PM

#

To help others find answers, you can mark your question as solved via Right click solution message -> Apps -> ✅ Mark Solution

swift berry Apr 16, 2024, 4:06 PM

#

Follow up replaced the tool board and even though I’m using a pt1000 thermistor on uhf plus 2 it shows add out of range if I have sensor type pt1000 and 110 degrees over actual temps if I dont use it was fine before a ratos update though

sour plover Apr 16, 2024, 9:37 PM

#

attach your printer.cfg

swift berry Apr 16, 2024, 9:43 PM

#

📎 printer.cfg

sour plover Apr 17, 2024, 1:32 AM

#

You have "sensor_type: PT1000" commented out. Remove the # from in front

swift berry Apr 17, 2024, 9:54 PM

#

Yeah with it not commented out I get the error with it commented my hotend shows a temp of 130

swift berry Apr 18, 2024, 6:48 PM

#

Im still very stuck with this

#

ah so it seems you no longer put on the jumper for pt1000

#

its working now to try get the tachometer and pwm of the part cooling fan on beta 1.2 working the pinout doesnt seem to match the btt spec

#weird error toolboard related