got a problem with an euclid probe that worked previously, it can't home as it return an error as if triggered or as if the probe wasn't attached so i checked the wiring (shitty dupond connector) redid it using hot glue so no wiggle and still the same as soon as it pick the euclid from the dock it trigger the security mode
#probe deployed but error triggered
ancient mauve
probe deployed but error triggered
i redid the test with a male male adapter on each end (both are female plug) to retest the connection i got a good continuity along each one and the euclid is still good looking the soldring look fine and btw the exposed solder are isolated bye hot glue so nothing there i believe its a software kind of hell
ancient mauve
can some one pls give me an idea of the problem ? in doubt i re did all the wiring with new wire and plug it worked fine once and then back at it again so itshould be a hardware problem right? i unscrewed the euclid and removed the glue covering the solder everything is fine .... is the mother board bad?
ancient mauve
hi pls someone i am still stuck on this ... as said i redid the wiring integraly and it worked for a bit ":17:06
Probe triggered prior to movement
17:06
Probe triggered prior to movement
17:06
Probe triggered prior to movement
17:06
Probe triggered prior to movement
17:06
probe at 270.422,256.741 is z=4.090000
17:06
probe at 344.581,256.741 is z=4.164375
17:06
probe at 418.742,256.739 is z=4.229062
17:06
probe at 492.902,256.739 is z=4.249062
17:06
probe at 492.902,183.411 is z=4.258750
17:06
probe at 418.742,183.411 is z=4.231562
17:06
probe at 344.581,183.409 is z=4.132187
17:06
probe at 270.422,183.409 is z=4.067812
17:06
probe at 196.263,183.409 is z=4.075312
17:06
probe at 122.102,183.411 is z=4.260625
17:06
probe at 47.942,183.411 is z=4.066562
17:06
probe at 47.942,110.080 is z=4.227812
17:06
probe at 122.102,110.080 is z=4.195312
17:06
probe at 196.261,110.080 is z=4.153125
17:06
probe at 270.422,110.081 is z=4.130937
17:06
probe at 344.583,110.080 is z=4.187812
17:06
probe at 418.742,110.080 is z=4.247812
17:06
probe at 492.902,110.080 is z=4.293437
17:06
probe at 492.903,36.750 is z=4.177500
17:06
probe at 418.741,36.750 is z=4.095000
17:06
probe at 344.581,36.750 is z=4.020312
17:06
probe at 270.422,36.750 is z=3.964687
17:06
probe at 196.263,36.750 is z=4.039062
17:06
probe at 122.103,36.750 is z=4.097187
17:06
probe at 47.941,36.750 is z=4.169062
17:06
Probe batch mode enabled: already deployed"
i don't understand how it could do like 20 probe point and fuck up like that
lapis ice
Sorry, my only issues with probe was me forgetting to put the build plate back after a print.
Is the Euclid probe a contact or non-contact?