PT1000 Thermistor setup. | Rat Rig Community [Unofficial] | Page 1

glass loom Mar 17, 2024, 11:42 PM

#

Trying to understand using a PT1000 Thermistor but between the RatOS install guide and the EBB36 V1.2 manual. I am conflicted on if I should be using the same pins as the standard NTC104 thermistor or the ones connected to the MAX 31865 chip.

zealous gyroBOT Mar 17, 2024, 11:42 PM

#

To help others find answers, you can mark your question as solved via Right click solution message -> Apps -> ✅ Mark Solution

glass loom Mar 17, 2024, 11:43 PM

#

strong ice Mar 17, 2024, 11:53 PM

#

glass loom Trying to understand using a PT1000 Thermistor but between the RatOS install gui...

Use the standard 2p thermistor port. Then in user overrides in printer.cfg do:

[extruder]
sensor_type: PT1000

I recommend putting in the PT1000 jumper (see the ebb manual) for increased accuracy, and then it's this:

[extruder]
sensor_type: PT1000
pullup_resistor: 2200

#

MAX31685 really only makes sense for PT100

#

and you'd be very hard pressed to find a practical difference between the two

glass loom Mar 17, 2024, 11:56 PM

#

So I just had the Pullup resistance wrong. 2200 vs 4700... BTT doing things weird again.

#

Well now that Beacon and Dragon UHF are installed and hopefully working well... I won't need to mess with Klipper again for a while after tuning again. Thanks again @strong ice

#PT1000 Thermistor setup.