scenic halo
Hey guys, as I am still hunting some usb communication issues, I wanted to turnoff hyperlapse in order to reduce the load produced by my webcam.
I ticked the checkbox to "disabled", but still hyperlapse seems to be called when starting a print. Am I doing something wrong?
Regards!
weak sun
Hey guys, as I am still hunting some usb communication issues, I wanted to turno...
Forgive me i don't remember the details of the timelapse plugin but i believe it's partly a slicer thing too
weak sun
I dont call it in my slicer at all.....
there's a layer change macro and some other stuff.
Don't remember if that's based off of Z height though.. I just don't remember, check the docs,.
scenic halo
there is no layer change macro.. I only call the adaptive mesh
weak sun
anyone....?
Try disabling “save frames” as well
scenic halo
Nope… no success
weak sun
Nope… no success
Comment out the timeline section in printer.cfg / moonraker.conf then i guess
Weird, but not RatOS related, i'd ask over in the mainsail discord wtf is going on.
scenic halo
I commented out the timelapse sections in printer.cfg and moonraker.conf, but then after I rebooted I got this:
weak sun
I'd start looking for those commands in your config
This is something you've somehow added yourself (something you added is calling those).
Timelapse isn't a native part of ratos, the repo is just preinstalled.
You may need to restart klipper through the services menu in mainsail. Not sure.
actually rebooting would do it too. (all i see in your pic is a firmware_restart)
