Hello. After loading up an object in my slicer and printing, I am getting this message constantly in the console section of RatOS. Is this a common issue?
#Exclude Object
brazen knoll
lament steeple
Hello. After loading up an object in my slicer and printing, I am getting this m...
No you're just using a slicer that uses exclude_object and didn't follow the installation instructions 😄 I assumet you're using Orca Slicer? You can enable exclude object by doing the following:
moonraker.conf:
[file_manager]
enable_object_processing: True
printer.cfg:
[exclude_object]
That's all.