wise radish
Is there some trick to getting my UHF to be able to UHF? I can't seem to print over about 12mm/s flow rate. After lots of testing, its because of friction in the bowden tube.
I have tried using large 3mm ID tube, and using the capricorn tube, all sorts of stuff.
Is there some trick to routing it in a way to make it smooth? Do I need to hang my filimanet on the ceiling and remove the top enclosure panel and let it feed straight down?
If I remove the PTFE and feed filament straight into the extruder, it feeds super fast. Its all related to having to pull through the tube.
And if I print over 12mm/s feed, I get cracks in the walls...But, thats dumb, whats the point of UHF if I can't feed fast enough?
jagged snow