arctic ravine
I have been trying to bring my FLY SHT-36V2 & FLY UTOC-3 up and running on my 500er with SKR 1.2 board. But it has been a hassle......and yes I know "NO CAN NEEDED" but i did buy it just when it was released and it had not been clear to me that this board did CAN ONLY.
However still tried as I did not want to extend my Inventory of Dust Collection devices...
Any Help is highly appreciated
Here are my files
My 3.1-500er Printer has been running over 1 Year now and I i'm very happy with it.
So the problem occurred with the setup of the FLY-SHT36V2 Board
Setup:
Distro: RatOS v 2.0.2 (bullseye)
Toolboard: FLY SHT-36V2 in combination with FLY UTOC-3
This is the Checks i did in the pi@ratos, for me it looks the can Link is up and running
on Klipper side i tried to use the Ratrig structure as much as possible, so i took the "/config/RatOS/boards/mellow-fly-sht-36/toolboard-config.cfg" and adjustet the pins to match the V2 Board and put the config in to the printer.cfg
Please find here the Relevant section in Printer.cfg
and this is my wiring:
This is just a test Setup and will be cleaned up after everything is working
neat gazelle
Hi, please use #klipper as CAN is outside the scope of RatOS support.