craggy swan
500mm enclosed build. Spent the day squaring the frame. There was some damage to the build plate during shipping so I'm not sure if its flat or not. In order to get this mesh I needed to add a 2mm gap between the right side of the electronics panel and the y gantry, the height from the bottom extrusion to the top of the y gantry is now 2mm longer on the right side. I think I might just be compensating for a bent build plate by taking the frame out of square though.
I'm planning to check pretty much every frame measurement for squareness, but I have a feeling I'm going to end up disassembling the whole thing if I do that. Any advice would be appreciated!
small crater