fix-my-printer
X Axis Skipping on print Startup
motion
Solved
VAOC LED ring not working
setup
Heater fault
other
Beacon Bed Level Sensor not having enough accuracy whilst bed is at temperature.
Solved
setup
VAOC not working - camera not connecting
Solved
setup
Z wobble or extrusion issues?
motion
How do I stop END_PRINT from calling M84?
other
Z-Tilt issues (most likely awd causing this)
motion
Solved
Layer shift - stepper skipping suspected
motion
V-core 4 unstable temperature so print wont start
other
setup
Problem with config my hotend with EBB 42
setup
VAOC Thermal Expansion Config
Solved
setup
Nozzle gets closer to the bed every time during first layer (worse at higher temps).
other
Vaoc - not working
setup
New machine vcore 4 machine with idex installed before commissioning
Solved
setup
My New Chonk build rear z motor doesn't move during homing.
motion
Solved
setup
Toolhead x-offset is too high for the available parking space. V-Core4 IDEX
setup
Beacon probe failing to pass BEACON_RATOS_CALIBRATE
Solved
setup
VCORE 4 MCU LOST COMMUNICATION
Solved
setup
fan control swapped
Solved
other
setup
Z-Offset being ignored
other
Part cooling fan issues after printer upgrade
Solved
other
Layer shift for just one layer and then back again?
motion
Solved
Printer crashes when heating bed
Solved
other
Clogging issues with Revo hotend
other
PAUSE does not park, only raises Z height
setup
Printer going totally wrong while Z-Tilt
setup
Lost communication with MCU 'beacon'
motion
Solved
Belts shifting and chewing up the edges
motion
Rapio 2 UHF thermal runway issue
Solved
other
Lost communication with MCU 'toolboard_t0'
Solved
other
Problem/Errors: Commissioning Guide | Step 2 - Build plate prep.
setup
BLtouch deploying but not triggering
setup
PART COOLING FAN not coming on ?
other
(straight) Rear leadscew is wobbling
motion
Solved
Temperature issues V-Core 3
other
At the end of my sanity; hopefully someone has the golden tip
motion
setup
Debris in heatbreak, wonky rapido thermistor?
Solved
other
Klipper reports: ERROR
Solved
setup
V-CORE MGN12 Linear rails gone rusty : how to protect steel bar from rust ??
motion
Rat Rig V Core 3 - Duet Board - RepRap Firmware
setup
bed wiring instructions for vc4
Solved
setup
ebb36 1.2 heater always on
other
Timer too close on V-Core 3.0 500 with Klipper
Solved
setup
Temperature Wait issue
other
Need help please: „Error during homing contact: Contact triggered while accelerating“ /RatRig V4 500
motion
other
setup
Filament Jam with 10kg spool
other
TMC 'stepper_y' reports error: GSTAT: 00000004 uv_cp=1(Undervoltage!)
motion
Solved
setup
Can I use a creality adxl345 accelerometer for my DIY ratrig 4?
motion
Huge Layershift
motion