ratos-support
Printer Hardware Missing from Configurator Setup Wizard
Solved
Errors
Configuration
stepper config , cant select the drivers that i am using using the ratos configurator
Solved
Configuration
How do I stop the end print macro from clearing the homing state/turning off the motors?
Solved
Macros
Configuration
Motion
I just updated to 2.1 and have a slicer issue.
Solved
Configuration
"MCU 'toolboard_t0' shudown: ADC out of range" extruder temperature -125 not in range 0:350
Solved
Configuration
Z-tilt configuration
Configuration
I don't know how to install RatOS on a currently unsupported host HOST(Mellow Fly Mini Pad)
Configuration
Boards
Other
move out of range issue
Errors
VORON 2.4 SPEED DURING BEACON
Macros
Configuration
Errors
Motion
How to activate a PWM Fan with two PWM Ports
Customization
Ratos configurator 502 gateway error
Errors
Configuration
Vcore 4 400 IDEX - Z-Offset
Solved
Errors
Configuration
Orcaslicer 2.3
Solved
Other
VAOC calibration
Solved
Macros
Configuration
Errors
Having problem with the skew profiles
Macros
Configuration
Customization
Z Macro travel speed
Macros
Configuration
Motion
**RatOS Configuration Repository**
Solved
Errors
RatOS-v2.1.0-RC2 No boot
Solved
Errors
Configuration
Firmware restart button doesn't work until I reboot the RPi
Errors
Configuration
Boards
The configuration manager has me stuck on "Waiting for DFU...". No options to flash, just waiting.
Errors
Configuration
Boards
Bedmeah calibration
Configuration
Configure new Hybrid 3.1
Solved
Configuration
Any way to functionally rename the [T0] macro?
Customization
Incorrect print history time after first print
Other
Prime blob volume
Configuration
Other
Rat Pack Fan without PWM
Customization
A simple way to prevent RatOS from regenerating printer.cfg
Customization
Boards
Chamber Heater Control
Macros
Customization
I am trying to connect a BoxTurtle to my Ratrig V4. The machine runs on RatOS 2.1.X
Macros
Tangle / clog detection on/off?
Configuration
Macros
Customization
temperature_MCU toolhead
Customization
Adjusting the Z-speed for V-Core 4.0 IDEX using RatOS 2.1
Solved
Configuration
Customization
Motion
Installing a Cartographer to my 3.1 Vcore
Configuration
Customization
Boards
Other
T1 hotend trouble
Macros
Configuration
Errors
Other
Hybrid to IDEX.... no T1 but two T0
Solved
Configuration
Boards
Other
How to address Host (RPI) gpio pin
Solved
Macros
Configuration
Customization
cant flash board
Configuration
update to 2.1 RC3 gives configuration error: 'allow_unknown_gcode_generator' is not valid
Solved
Errors
Configuration
ratos-configurator.service stuck
Configuration
No longer able to connect
Configuration
Boards
RatOS update all components stuck
Solved
Errors
Running ethernet via a pc
Configuration
Extrude Only Move Too Long error during filament unload macro
Macros
Problems flashing the Octopus board, possibly
Errors
Configuration
Boards
502 Bad Gateway error with RatOS v2.1-RC2
Solved
Errors
Configuration
chamber thermistor saying -40
Macros
Configuration
Other
Raspberri Pi issue?
Configuration
First layer squish (possible thermal expansion)
Errors
Configuration
Reboot issue
Errors
Other
Cancel Print Button Not Working
Solved
Errors