ratos-support
RatOS 2 and Rasp Pi v3 cam
Configuration
not seeing Octopus Max for a control board in printer setup. Ratos V2.0.2
Solved
Configuration
Problem with Linear rail
Other
changing wifi setting in raspberry pi.
Solved
Configuration
ratrig V3.1 500 for probe chose.
Solved
Other
Wrong hotend temperature
Solved
Errors
Configuration
remote access/port forwarding
Configuration
Other
raspberry pi camera module 3
Other
Part Fan not working as it should
Configuration
possible Z stepper issue?
Configuration
Fresh RatOS install x2 and still can't get the MCU to respond
Solved
Errors
Boards
Changing WiFi
Customization
endstop z still triggered after retract
Solved
Motion
Other
Brand new and having klipper errors. I have attached the printerconfig.
Solved
variable_adaptive_mesh fault with Bl-Touch
Solved
Configuration
Changed position BLTouch
Customization
Y home
Solved
Configuration
Printer is printing prime blob in the middle of the bed!?
Configuration
Motion
Custom-made extruder
Customization
adaptive bed mesh
Solved
Macros
Configuration
Errors
Z-Axis Crash during homing after tall prints
Macros
Configuration
Motion
ratos Kernel panic-not syncing: VFS: unable to mount root fs on unknown-block(179,2)
Errors
PAM Invalid
Macros
Configuration
How do i find out which Username & PW to use if i forgot them?
Solved
Configuration
I loose camera's during printing
Configuration
I installed a btt smart filament sensor 2.0 but it gets triggered by the beginning purge of rat os.
Configuration
Pre-heating extruder...
Solved
Customization
How do I manually flash my Octupus after a failed flash?
Solved
Errors
Hot end heater pin migration problems.
Solved
Errors
Configuration
Boards
Dxf to G-Code
Solved
Info
Customization
LDO ADXL with RatOS v1.1
Solved
Configuration
MCU Protocol Error after updats
Solved
Errors
custom bed mesh
Solved
Configuration
ratos-configurator showing as invalid
Configuration
MCU 'mcu' shutdown: ADC out of range
Solved
Configuration
Customization
SD card flash keeps failing.
Solved
Does Prime Blob adjust for Nozzle Size?
Macros
Configuration
Printer Speed Settings for VCore 3.1 400
Solved
Configuration
Boards
Customization
Motion
bed keep hiting nozzle
Other
Section 'ratos_homing' is not a valid config section
Solved
Info
Configuration
Customization
WiFi off when ethernet cable is disconnected
Errors
Octopus V1.1 (F446) SuperPinda Probe Always Triggered on
Solved
Errors
Upgrade to Btt Octopus ProF446
Solved
Configuration
Boards
Manta M8p 2.0
Errors
Configuration
Boards
Octopus V1.1 detected but is unresponsive.
Solved
Errors
Configuration
Boards
DFU not detected, BTT board not detected, can't flash my BTT Octopus v1.1
Solved
Errors
Boards
Bridging problem with rapido UHF and 0.6mozzle
Configuration
Other
Today I upgraded to newest version of Beacon and Z tilt is not working.
Solved
Errors
Boards
Motion
MCU issues
Solved
Configuration
Boards
prime blob code
Solved
Macros
Info
Customization