Im new to photoshop and I have a photo I want to remove all the people from the photo but I searched videos and they only show how to remove basic stuff
#Help removing people from photo
proven storm
mental elm
proven storm
How can I fix the back and under the wing?
proven storm
@mental elm ??????
mental elm
How can I fix the back and under the wing?
In the centre, it is even good if one person is found and replaced at a time. This is because the wall is taken into account.
In my opinion, the AI unfortunately no longer has the option of subsequently including the wall in ‘your result’.
Difficult question. Because there are really only two options. Either you start again and trust the AI to do a better job - or you retouch manually. One costs credits and the other requires a lot of experience.
proven storm
In the centre, it is even good if one person is found and replaced at a time. Th...
I was able to mask out the car. How would I go about adding a brick background and floor similar to that and make it not look like 1 wall
also thoughts on the mask?
mental elm
If the car is on its own layer (hopefully with a layer mask!) then just try adding Generative fill to the background layer.
proven storm
If the car is on its own layer (hopefully with a layer mask!) then just try addi...
I got this and when I did gen fill I got nothing close to the back
nvm I got it
Thank you so so much
mental elm
Thank you so so much
It is usually advantageous to use a hard selection edge.
proven storm
It is usually advantageous to use a hard selection edge.
how would I go about removing the glare and reflections
mental elm
how would I go about removing the glare and reflections
you can try gen fill - or the hard and rocky way with the Remove Tool
proven storm
you can try gen fill - or the hard and rocky way with the Remove Tool
How would I move the car so its centered
Like the car is more to the left
proven storm
@mental elm ????
mental elm
<@1260686485842296977> ????
I am very rarely online at 4.00 am on a Sunday morning.
Please excuse me for sleeping at these times.
If you were to ask the question in general to everyone (and not just ping me), then it is more than likely that the many other helpers here on the server will also be able to help and advise you.
But to your question: You have the car on its own layer. Then simply move the car to where you want it. Activate the layer and use the Move tool.
Or have I not understood your question?
proven storm
I am very rarely online at 4.00 am on a Sunday morning.
Please excuse me for sle...
oh your not EST, my bad