#Performance Problems because of the Base.

19 messages · Page 1 of 1 (latest)

dawn linden
#

So if i start the game and go in the radius immediately it will run very smooth no frame drops or lags at all. But if i spend more than about a minute in the base it will become a slideshow, with my whole pc lagging very hard, if this happens and i go into a mission and load in the map the performance will stay at that level until i restart the game. Happens every single time. Tried it with all settings on the lowest and render scale at different percentages but it doesn't seem to matter.

Quest 3 same with or without steam vr

Ryzen 5 5600x
Amd RX 6600xt
16gb ram

golden moth
#

What do you use to connect your quest to your PC?

dawn linden
#

a link cable with a powerbrick

dawn linden
#

the connection test says 2,5 Gbps

golden moth
#

then i have no idea, i would have assumed it was a codec issue but it's usb c to usbc so it can;t be

modern robin
#

does the desktop view also show the same poor performance or is it smooth

dawn linden
#

yes my entire pc stutters. i have tried a few of the workarounds but it didn't seem to matter

hollow stream
bitter zodiac
#

I've only noticed degraded performance over time on my save 🤔

golden moth
#

What resolution are you using?

dense pilot
#

im having the same issue

dawn linden
#

i have found the problem. now its running very well on high graphics settings with occasional small stutters

#

i just turned off my other screen while playing. Weirdly only seems to be affected by one connected with hdmi

hollow stream
dawn linden
#

Yeah

#

I had some bad performance in the forest map of itr2. Switched from 90hz to 72hz

#

Now it works fine if i have :

No open browser
Only two screens
And 72hz (doesn't seem to matter much how high i set the graphics)

versed heart