#4" explorer lr4 o4 pro spins out of control sometimes
74 messages · Page 1 of 1 (latest)
uploading rn
dvr is here cropped to right before the crash
ive actually got no idea if that blackbox is right
have i done something wrong in the motors settings
it was flying fine for a minute or so
i would say its a desync or a motor wire came off
how do i find out which
and what do i do
motor wires look fine
electronic speed controller
i bought the drone pre assembled from flywoo
i just installed the o4 pro
it happened yesterday aswell but not as bad
and what to do
how can i test this
pull on them
they are taped down
at where they go onto the esc
one of the arms did break a little and i super glued them back on
it does feel 100% secure but could that be it
it was happening before though
dude
which arm?
what
dont superglue carbon back together
oh
seems like the rear left motor is the problem
howcome
because i looked at the log?
yeah but the new ones will take 8 days to arrive
wait could it be i didnt screw props in
yeah that would probably do it 
there are 2 extra holes on the props maybe i have to screw them
ok im stupid im so sorry
now ive got 4 lost props and have to wait 8 days
the shaft just slips if you have no screws
im accustomed to whoops
just gonna have to wait for my flywoo order then 😭
what screws are they for the props there are so many in the box
m2x7
appreciate it bro
Well
On one hand silly expensive mistake
On the other hand, you dont have to chase any gremlins lmao
Ive done similar, had a 7" fall out of sky from a loose fc connector
yeha
it caused the crash where the frame broke a bit
not really expensive mistake but annoying because now i have to wait 8 days
😭
i appreciate all you guys for the help
When my 7" fell from the sky because of that fc connector, it snapped an arm and bent some frame hardware, i ordered the wrong arm, only found out after i got the free time to work on, had to order another set of arms...
It never ends lmao
But eventually you wind up with more spare parts on hand
Everything gets easier the longer you work with it
yeah
i knew it would be like this eventually but i was hoping buying tons of parts would be later
that is exactly what happened actually
this is what happens to the LR4 without screwed in props